Oberdorfer 109MB-1-J26 Bronze Centrifugal Pump 115-230V

Oberdorfer 109MB Bronze Centrifugal Pump

Oberforfer 109MB-1-J26 is commonly used in marine air conditioning systems up to 150,000 BTU. It is equipped with a Monel shaft for corrosion resistance. Motor: � HP 115/230 Volts 60 Hz. Open Drip Proof housing Inlet Port: 1-1/4� female pipe thread Outlet Port: 1� female pipe thread Gallons per hour at 0 feet of head: 4200 Max Head: 44 feet Replaces Cruisair PH3000BX and Aqua-Air AQPM-30 Note that this pump has a Monel shaft which is much more corrosion resistant in salt water than the more common stainless shafts.

Rugged Bronze Construction

A Standard in the Marine Air Conditioning Industry

Extremely Quiet Operation

O-Ring Housing seal eliminates gasket problems

Teflon Barrier Seal to protect motor bearings

Handles Contaminated Liquids

Discharge port orientation flexibility-8 positions

Mechanical Seal - Carbon/Ceramic

Buna - standard

Viton (S10) optional

Teflon (S11) optional

Pump Heads mount to standard footed Nema 56J Jet Pump Motors

Shafts: 416 Stainless, Monel, or 316 Passivated Stainless

Multiple motor options available

For Industrial Version - see Model 700 series

LIQUIDS

The special pump alloys used provide corrosion resistance to many liquids including water, water solutions, and a wide range of commercial chemicals.

Questions as to the chemical compatibility of special liquids should be referred to the factory.

Viscous liquids with a maximum viscosity of 2000

Saybolt Seconds Universal can be pumped. However, when pumping viscous liquids as compared with water, a reduction in flow and pressure occurs and the required horsepower rate increases.

Liquids heavier than water require additional

PERFORMANCE

horsepower in direct proportion to the increase in specific gravity. Liquids contaminated with small solids or abrasives can be

handled, but a reduction in mechanical seal life must be expected.

CHARACTERISTICS

This close-coupled pump uses a standard NEMA CFlange Jet Pump Motor with weld-on base and threaded shaft end to accept the pump impeller. Single phase motors are nonreversible and are wired for the proper pump rotation which is counter-clockwise looking at the inlet end of the pump. (See the dimensional drawing on back.) Three phase motors must be checked out for proper rotation when the pump is installed. Interchanging of any 2 wires in a 3-phase system will reverse motor rotation. The pump uses a mechanical type shaft seal with a Buna N rubber element. It is suitable for water, oils, and some mild solvents and it is limited to 212o F and 75 P.S.I. Viton(R)* seals and Teflon(R)* seals are available for severe solvents and difficult chemicals.